![]() Please advise on how this can be resolved.Ģ) Open Control Panel -> System and Security -> Administrative Tools -> Services (right-click the bottom-left Start Screen icon to get to Control Panel in the first place)ģ) Stop both the "ShrewSoft IKE Daemon" and "ShrewSoft IPSEC Daemon" servicesĤ) Verify both services have stopped (F5 to refresh view) The same problem was occurring with v2.2.1 (which I had initially tried "ipconfig" command output does not show anyĭifference between when (VPN is connected and) VPN is working and Identifier, Key ID string, (Remote ID: ID Type: Any) and Options: [NAT Traversal: enable, Port 4500, Keep-alive: 15 sec, IKEįragm.: enable, Max packet size: 540 Bytes, Enable Dead Peerĭetection, Enable ISAKMP Failure Notifications, Enable Client LoginĪuthentication method is "Mutual PSK + XAuth", with ID Type: Key VPN appears to be up (by the way, I wouldĮxpect Shrewsoft VPN Client to understand the outage and drop theĬonnection automatically) If I attempt to manually Disconnect anĬonnect again, I find myself in the above situation (VPN ClientĪdapter mode is "Virtual adapter and assigned address" (AutoĪddress/Netmask), MTU 1380, Auto Config: ike config pull, The same happens if Ethernet connection (physically) drops temporarily Manually, it will need a reboot for the VPN Client to work correctly. Works fine to establish a new connection. If I manually disconnect before Standby, then, after Standby VPN Client Laptop is put to Standby mode by closing the lid, while VPN is active. This is a consistent, reproducible problem. Re-enabling the Ethernet connection, but nothing works. Have tried restarting the Shrewsoft VPN Client, disabling and More) cannot be resolved in any way, except by rebooting the machine. Shresoft VPN Client effectively not working any Public IP addresses does not work either - so it's not a DNS problem. Possible, nor VPN access to our Org internal network. Private network I am on a DSL line.) Neither usual Internet access is ![]() Issues), no Internet access is available (except local, on my home not using an explicit -manual-ĭiscconnect), then, the next time VPN is -explicitly, pressing theĬonnect button- established (VPN seems to be established without The problem: If an established VPN Connection (over Ethernet, using UTPĬabling) is interrupted abnormally (i.e. I am running Shrewsoft VPN Client v2.2.2 (Free Version). It connects to a Cisco 3825 router running IOS v12.4(9)T2. Recently, I have started using a Dell laptop running Win 8 Pro 64 bit. First of all, thanks for your great piece of software, which I have been
0 Comments
Leave a Reply. |